21
EN
188 mm
127 mm
ca. 350 mm
Mount the display panel as described below.
Observe illustrations given on pages 22-24.
1. Determine the installation position.
2. Make a cut-out in the wall with dimen-
sions 127 mm height x 188 mm width (see
pic. 5, 7, 8).
3. Installation depth - min. 35 mm needed.
4. Draw the connection cable from the main
relay box to the control panel.
5.
Important
: the bigger plug (RJ12) shall
be oriented to the relay box (steam gen-
erator) and the smaller plug RJ10 to the
display panel.
6. The connection cable(s) should be drawn
between the wall insulation and outer
wall cladding (pic. 10).
7. The walls shall be insulated so that the
max. temperature cannot exceed 75° C.
8. Connect the display panel to the relay box
(steam generator) as described on the
page 22.
9. The connection line may be extended up
to 50 m. For this you will need to use a
standard coupling RJ12/RJ12 and an ex-
tension cable with RJ12 plugs in required
length. The coupling and extension ca-
Pic. 5
6. Display panel
The display panel may only be mounted out-
side the cabin.
Make sure that by the door opening the
steam may not reach the control unit. This
may cause water condensation on the display
panel and damage the entire system.
If ductwork is already provided for electrical in-
stallations then the position of the control unit
is predetermined by that. The display panel is
designed for flush-mounted installation into
the cabin wall or a similar adja cent wall.
bles are available as optional accessories.
10. If the connection line is over 25 m you will
need an additional power adaptor. This
adaptor shall be installed next to the con-
trol panel and requires 230V. See optional
accessories, page 12. It connects to the
power adaptor power jack (pic. 6).
Attention: Maximum connection line length
for the display panel is 50 m. By the cable
length over 25 m an additional power adap-
tor is required.
The smaller RJ10 plug of the connection cable
should be directed to the display panel.
Handle the display panel with care! Do not
drop! Remove the protective film from the
glass front only after the final installation.
ATTENTION! Bei installation of the connec-
tion line DO NOT pull the cable by holding
the plug! This will damage the cable.
ey
e lev
el
