42
EN
Programming of the cabin address (ID).
The relay box of the sauna control unit or the main board of the generator are shipped from fac-
tory with the default cabin address #1. In order to operate multiple cabins you have to reprogram
their cabin address and assign them the new unique ID from 2 to 8 depending on their connection
position. The display panel will be able to detect the new cabin only if it has been assigned the
correct new address (ID).
Overview for the cabin address assignment depending on the connection position:
1
st
port
1
st
cabin - address 1
2
nd
cabin - address 2
2
nd
port
3
rd
cabin - address 3
4
th
cabin - address 4
3
rd
port
5
th
cabin - address 5
6
th
cabin - address 6
4
th
port
7
th
cabin - address 7
8
th
cabin - address 8
Important notice:
Make sure to strictly observe the connection sequence for every additional
cabin. Connections must begin from the 1
st
port. A cabin with the particular ID may be connect-
ed only the appropriate port as indicated above. For instance, a cabin with the ID 4 may be only
connected to the port #2. Otherwise it will not be detected and may not be used.
Programming:
1. Press the programming button for 5-6 sec until the green flashing LED on the board goes out
and a red LED next to it lights on (active programming mode).
2. Now press firmly one time on the programming button. The
cabin address will move one number higher. The green LED will
flash the number of times as the new cabin address (from 1 to 8).
Example: old address = 1 > press the button > LED flashes 2 times
> new address = 2.
3. Press on the programming button again until you reach the
required cabin address. With every pressing on the button the
cabin address count prog1. If you have reached the
required address wait for some 15 sec - the program mode will
exit (red LED goes out, green LED starts flashing again). In this
manner you can set the address from 1 to 8.
Once the new cabin address has been assigned and if the cabin
has been correctly connected, it will be automatically detected
and the multi-cabin control symbol will appear on the display.
F1
F2
JP5
}
}
X5
X2
X3
STB
L1
U
L2
V
L3
W
N
N
N Wb Wm S1 S1 3 4 FL FN LL LN
}
I
II
programming
button in the sauna
control unit relay box
By SteamRock Premium generator the
programming button is on the main board
next to the sauna bus connector.
On the page 37 you will find the connection overview with the example of connections for 8
cabins (mixed saunas and steam rooms).
