50
EN
Cabin light on/off
Press the lamp on the display briefly to switch the light in the steam
bath cabin on or off.
Light dimmer
You can dim the cabin light infinitely (0 - 100%)
to your preference.
Touch the lamp symbol on the display for more
than 3 sec. The cabin light turns on (if off be-
fore) and a sub-menu with the current setting
will appear. By pulling the slide bar up or down
you can adjust the light intensity.
!
Attention! Make sure to use only dim-
mable lamps! Otherwise the control unit may
be damaged!
Timer
This function allows to pre-set the start time up to 24 h in advance.
Alternatively you can program the single start time to any date in
the future or set a week timer. Open the extended settings menu
via the symbol
. Tip twice on the timer symbol
to open the
timer sub-menu with three options: 24 h time pre-selection, single
event timer, serial event timer (week timer).
24 h time pre-selection (Auto Start)
This functions means start time pre-selection for a single switching within 24 h.
•
Select the symbol
and touch it briefly again to launch a sub-menu for programming.
•
Set the desired start time using the „+“ and „-“ buttons.
•
Confirm your setting with the green check symbol.
•
The programmed start time will appear flashing in the bottom line on the screen.
•
The heating time duration will be as per “Auto-Stop” setting (page 47).
Notice that the programmed time means the real time, not the time delay. In order to cancel this
program set the start time back to „--:--“ and confirm the setting.
Single event timer
(single switching on any day in the future)
For the single event timer touch twice the symbol
to launch the sub-meu for programming.
•
First set the day, month and year by using the „+“ and „-“ buttons.
•
Next set the desired
Start time
(hours and minutes).
•
Then set the desired temperature.
Settings
Timer
Auto-Start
31. Oktober 2016
14:22:38
0:22:38
31. Oktober 2016
14:22:38
3
Settings
Light
70%