49
EN
Switching the heating ON/OFF
Press the
symbol for approx. 3 seconds. The heating will switch on and the display will show
the active heating mode (see example on page 24). The light will be also switched on.
To switch off the heating, touch the
symbol again. Please notice that after the main heating
program the extractor fan will be automatically switched on to dry the cabin. This function may be
adjusted or disabled in service level settings.
To stop the extractor fan operation briefly touch once again on the
symbol.
Temperature setting
Touch the steam outlet symbol for 3 sec. A submenu will open - in this submenu you can set the
temperature
and switch the
essence dosing
(pump 1 or 2). The control unit will show the last
saved setting.
For temperature setting pull the slide switch up
or down. The new setting will apply immediate-
ly as you take the finger off the slide switch. The
temperature value will be shown above the slid-
er bar.
Essence dosing control
The switching of the essence dosing effects in the same submenu as the temperature. Here you
can switch the pump 1 or 2 on or switch the dosing off.
1
- 1st dosing pump.
Tip on this symbol briefly to start essence dosing from the pump no. 1.
2
- 2nd dosing pump
Tip on this symbol briefly to start essence dosing from the pump no. 2.
- Stop essense dosing.
Tip on this symbol briefly to stop essence dosing.
NOTICE: The configuration of the pumps, such as dosing intervals and essence quantity per in-
jection, should be carried out upon setup in the service level set- tings. Please contact your local
dealer if you wish to have the basic settings for essence dosing adjusted.
31. Oktober 2016
14:22:38
3
Operation and program settings
31. Oktober 2016
14:22:38
3
Setting
Temperature
Essence
°C
40
1
2
