38
EN
Replacing the housing cover
Switch on the relay box and check if the green LED is flashing.
a) If the green LED is flashing, replace the housing cover.
b) If the green LED is not flashing, troubleshoot the problem and resolve it.
1. First put the lower then the upper cover halves in place.
2. Screw in the 6 screws.
Closing the relay box housing
The following work must be completed before
you close the housing:
• Connecting data lines
• Connecting and configuring consumers.
• Programming of the cabin address (chapter
Multicabin-Installation).
If the device is connected correctly and swit-
ched on, a green LED flashes on the main circuit
board after a short start-up period. This green
LED signals normal communication.
If the relay box in the plant room and the cont-
rol panel are far apart, the technician can iden-
tify the correct installation.
Summary of Contents for Emotec D
Page 68: ...68 DE...
