54
EN
After the 4
th
digit confirmation the display will return to the start screen and the unit is now locked.
Notice: make sure to remember the pin-code!
For safety reasons it is still possible to switch off the heater (interrupt active heating) and to switch
the light while the unit is locked. All other functions will be locked.
For all other operating attempts, the request for PIN code entry appears.
To unlock the unit rotate the jog dial in order to call the pin code prompt. Now give in your pin
code. The unit is now unlocked.
How to reset the pin code
Launch the pin code prompt (rotate the jog dial). DO NOT change the four zeros, press the jog dial
shortly to confirm the first zero, at the second zero press the jog dial continuously (the first two
zeros turn green, the cursor is under the third zero).
After approx. 40 seconds all four zeros will turn white. Now simply confirm each zero with the jog
dial. After the 4
th
digit confirmation the display will return to the normal start screen. The control
unit is now unlocked and the pin code is reset.
Heating time
Here you can set the required heating time duration for your sauna heater.
For private use the max. heating time is limited to 6 hours. For commercial use the max. heating
time may be limited to 6 hours, 12 hours, 18 hours or set to unlimited. This limitation should be set
in hardware during the installation and setup (jumper 5 setting)
Press with the jog dial on the
symbol and set the required heating time in hours and minutes.
This setting will be then valid for every manual sauna switching. You can of course stop the heating
earlier at any moment.
After switching the sauna on the remaining heating time will be displayed as a countdown clock
in the upper left corner. So you can check at a glance the remaining heating
time of your sauna.
Please observe that after the humid mode operation (only EmoTec H) the sau-
na heater will be switched in the „sauna dry“ mode in order to dry your sauna
cabin. The default sauna dry mode duration is 30 minutes. This time may be
reduced (also the pre-set temperature and fan operation time may be adjust-
ed) in the setup menu. Please contact your specialist dealer for further details.
The heating time may be changed with 1 minute steps. The minimal heating
time is 1 minute.
Operation data
Here you can check the important information concerning your control unit (sauna) operation.
Firmware
- allows to check the currently installed firmware version. Rotate the jog dial to
switch between two possible parameters. “Panel Vx.xx“ - shows the firmware in control panel,
“Mod-LS Vx.xx“ - shows the firmware in the main relay unit (x stands for a number). Press on the
jog dial to close this submenu.
20:51
4:23:14
Summary of Contents for Emotec D
Page 68: ...68 DE...
