Enterasys SecureStack C2, Configuration Manual

Page: 410 / 607

clear rmon event
13-14 RMON Configuration
Mode
Switch command, read ‐ write.
Usage
An RMON event entry can be created using this command, configured using the set rmon event
properties command (“ set rmon event properties ” on page 13 ‐ 12), then enabled using this
command. An RMON event entry can be created and configured at the same time by specifying an
unused index with the set rmon event properties command.
Example
This example shows how to enable RMON event entry 1:
C2(rw)->set rmon event status 1 enable
clear rmon event
Use this command to delete an RMON event entry and any associated log entries.
Syntax
clear rmon event index
Parameters
Defaults
None.
Mode
Switch command, read ‐ write.
Example
This example shows how to clear RMON event 1:
C2(rw)->clear rmon event 1
Filter Group Commands
The packet capture and filter function is disabled by default. Only one interface can be configured
for capturing and filtering at a time.
When packet capture is enabled on an interface, the SecureStack C2 switch will capture 100 frames
as close to sequentially as possible. These 100 frames will be placed into a buffer for inspection. If
there is data in the buffer when the function is started, the buffer will be overwritten. Once 100
frames have been captured, the capture will stop. Filtering will be performed on the frames
captured in the buffer. Therefore, only a subset of the frames captured will be available for
display.
index Specifies the index number of the entry to be cleared.
Note: Packet capture is sampling only and does not guarantee receipt of back to back packets.