Enterasys SecureStack C2, Configuration Manual

Page: 345 / 607

set port ratelimit
SecureStack C2 Configuration Guide 10-11
set port ratelimit
Use this command to configure the traffic rate limiting status and threshold (in kilobytes per
second) for one or more ports.
Syntax
set port ratelimit { disable | enable } | port-string priority threshold
{ disable | enable } [ inbound ] [ index ]
Parameters
Defaults
Threshold will be applied to inbound traffic on the port/priority.
If index is not specified, settings will be applied to index 1, and will overwrite index 1 for any
subsequent rate limits configured.
Mode
Switch command, read ‐ write.
Index Resource index for this port.
Threshold (kB/s) Port rate limiting threshold in kilobytes per second.
Action Whether or not frames not conforming to rate limiting will be discarded.
Direction Currently rules can only be applied to inbound traffic.
Priority List 802.1D (802.1p) port priority level.
Status Whether or not this rule is active or disabled.
Table 10-1 show port ratelimit Output Details (Continued)
Output What It Displays...
disable | enable When entered without a port ‐ string , globally disables or enables the port
rate limiting function. When entered with a port ‐ string , disables or
enables rate limiting on specific port(s) when the global function is
enabled.
port ‐ string Specifies a port on which to set the rate limiting threshold and other
parameters. For a detailed description of possible port ‐ string values,
refer to “ Port String Syntax Used in the CLI ” on page 5 ‐ 2.
priority Specifies the 802.1D (802.1p) port priority level associated with the port ‐
string . The value can be 0 to 7 , with 0 specifying the lowest priority.
threshold Specifies a port rate limiting threshold in kilobytes per second. Range is
64 up to a maximum of 2,147,483,647 kilobytes per second.
inbound (Optional) Applies this rate policing rule to inbound traffic.
index (Optional) Assigns a resource index for this port.