Enterasys SecureStack C2, Configuration Manual

Page: 310 / 607

show policy capability
9-8 Policy Classification Configuration
show policy capability
Use this command to display detailed policy classification capabilities supported by your
SecureStack C2 device.
Syntax
show policy capability
Parameters
None.
Defaults
None.
Mode
Switch command, read ‐ only.
Usage
Use this command to display detailed policy classification capabilities supported by your
SecureStack C2 device. The output of this command shows a table listing classifiable traffic
attributes and the type of actions, by rule type, that can be executed relative to each attribute.
Above the table is a list of all the actions possible on this device.
The left ‐ most column of the table lists all possible classifiable traffic attributes. The next two
columns from the left indicate how policy profiles may be assigned, either administratively or
dynamically. The next four columns from the left indicate the actions that may be performed. The
last three columns indicate auditing options.
An x in an action column for a traffic attribute row indicates that your system has the capability to
perform that action for traffic classified by that attribute.
VLAN VLAN ID to which this rule applies and whether or not matching packets will be
dropped or forwarded.
CoS If applicable, Class of Service value to which this rule applies. (Not supported on B3,
C3, and G3 devices.)
U Whether or not this rule has been used.
dPID Whether or not this is a dynamic profile ID.
aPID Whether or not this is an administrative profile ID.
Table 9-2 show policy rule Output Details (Continued)
Output What It Displays...