Enterasys SecureStack C2, Configuration Manual

Page: 158 / 607

set port trap
5-20 Port Configuration
Parameters
Defaults
If port ‐ string is not specified, the trap status for all ports will be displayed.
Mode
Switch command, read ‐ write.
Example
This example shows how to display link trap status for
ge
.3.1 through 4:
C2(su)->show port trap ge.3.1-4
Link traps enabled on port ge.3.1.
Link traps enabled on port ge.3.2.
Link traps enabled on port ge.3.3.
Link traps enabled on port ge.3.4.
set port trap
Use this command to enable of disable ports for sending SNMP trap messages when their link
status changes.
Syntax
set port trap port-string { enable | disable }
Parameters
Defaults
Sending traps when link status changes is enabled by default.
Mode
Switch command, read ‐ write.
Example
The following example disables sending trap on ge.3.1.
C2(su)->set port trap ge.3.1 disable
port ‐ string (Optional) Displays link trap status for specific port(s). For a detailed
description of possible port ‐ string values, refer to “ Port String Syntax Used
in the CLI ” on page 5 ‐ 2.
port ‐ string Specifies the port(s) for which to enable or disable port traps. For a
detailed description of possible port ‐ string values, refer to “ Port String
Syntax Used in the CLI ” on page 5 ‐ 2.
enable | disable Enables or disables sending trap messages when link status changes.