900-00277-01-001 Rev A
61
Operation
LED Indicator (Battery)
The Mojave ESS battery has a single LED indicator to show states of operation. Additional states
may be added in the future, using firmware updates, to reflect new features.
If the inverter indicates a state not shown here, please refer to the firmware release notes.
Alternately, consult an updated revision of this manual from
www.outbackpower.com.
Blue
— Battery is discharging or in a resting state. The Mojave inverter LED indicator (see page 28) will
also be blue if the system is not operating.
Green
— Battery is charging.
Red
— Error shutdown. See page 64 for troubleshooting. The battery icon in the
STATUS
view will turn
red at the same time. See page 17.
See
EVENT
view on page 24 for further descriptions of any status.
Battery Use
Commissioning
To commission the battery for ESS operation:
1. Confirm a valid bond between negative and ground. Check for voltage between points
H
and
J
in Figure
32 on page 60. The voltage reading should be zero.
2. Replace all covers. This step includes the exterior covers
L
,
M
, and
O
shipped with the unit, as well as
the interior cover
N
for the wiring compartment. Do not remove any other interior covers. Do not remove
the hex screws
P
. Install the covers
L
,
M
,
N
,and
O
as shown in Figure 33. Use a 5 mm hex (Allen)
driver to install the M6 screws and washers at locations
L
,
M
, and
N
.
Figure 33 Cover Replacement
4
5
M
L
N
O
L
L
L
L
M
M
M
M
P
P
N
N
N
N
P
P
4
5
