EnerSys Alpha FXM HP 1100, Technical Manual

Page: 92 / 150

0170022-J0 Rev A Page 80
Creating a FXM System from a Configuration File
A system can be created by importing from a configuration file. See the “Importing a System” section in
the CXC HP Controller Manual.
Configure the Basic FXM System Settings
The Configure System page has five tables (Configuration, System Properties, AC Input, AC Output
and Alarms with some basic settings that must be configured.
To setup an FXM HP system:
1. Go to
System > Configure System
.
2. In the Configuration table, configure the following:
a. Set the system name, description, system number and serial number.
b. Set the system float voltage.
3. In the
System Properties
table set the low battery threshold so it will trigger the
Low Battery
Warning
and
Low B No Line
alarms.
4. Set the Power Outage Alarm Delay so that power outages shorter than delay setting will be
ignored. AC Power Outage and On Battery alarms will not be triggered. Short power outage
events will be logged in the Power Outage Logs .
5. In the
AC Input
table, set the
AC Input Sense
.
6. In the AC Output table, set the Automation Voltage Regulations (AVR) mode.
7. In the
Alarms
table, configure the alarms.
Configure Output Voltage and Frequency for Bypass
Several parameters of the FXM HP must be configured if the system is to be put into Bypass mode. This
is to ensure that the power to the load would not be disrupted.
To configure an FXM HP system for Bypass mode:
1. Go to System > Configure System .
2. In the Configuration table, click on Configure FXM System wizard.
3. Click Next to start the wizard.
4. Select System Type : Normal UPS is for a system with battery backup, and AC Input Only is
without battery.
5. Select AC voltage and AC Frequency .
6. Click Next to complete the configuration.