0170022-J0 Rev A
Page 117
•
Controller description and location information (this is unique to each controller)
•
IP configuration (to avoid loss of Ethernet connectivity)
•
Web server port configuration (to avoid loss of Ethernet connectivity)
•
Line power channels (unique to line power modules)
•
Power module (power modules are unique to a system)
•
Users (to maintain password security)
•
Server passwords (e.g. email server password; to maintain password security)
To import settings:
1. From the main dashboard go to,
Controller > Advanced Functions > Configuration File
.
2. Click the
Import
button, select a file to import and click the
Upload
button.
3. If the configuration cannot be imported without ambiguity, there will be a drop-down list to select
the destination system or ADIO. This only happens if trying to do a partial import. Select the desti
-
nation system and click
Next
.
4. A page displaying an
Import Summary
is shown. Review the summary and click
Next
to import.
If the summary looks incorrect, you can close the wizard and try
Import
again to select another
file.
5. Perform
Replace ADIO
if required. When this operation is done, the controller gives special atten
-
tion to the status of relays mapped to a disconnect. If, as a result of the replace operation, a
disconnect relay will be shared with an alarm relay or if the state of a disconnect relay will change
because of a change to the relay polarity, the replace will fail and an entry made in the event log
identifying the alarm relay was causing the failure.
Importing a System
It is common to create a system on the controller that has been already configured on a different
controller. This can be done by first exporting a configuration file from the already configured
controller, then importing it. When exporting, choose the appropriate export method, either clone or
copy, as previously described.
To import a system in a configuration file:
1. Go to
Controller > Advanced Functions > Configuration File
.
2. Press the
Import
button to launch the import wizard.
3. Use
Select File
to browse to the configuration file on your local computer (e.g.
exportconfig.xml
).
4. Click
Upload
to upload the file to the controller.
5. Review the
Import Summary
page. This shows a summary of what you are about to import. If it
is not correct, close the wizard and start over to select a different configuration file.
Summary of Contents for Alpha FXM HP 1100
