Endress+Hauser Analytik Jena CyBio FeliX, Operating Instructions Manual, Page: 87 / 116

Rev. B 2022/02 73
CyBio FeliX
7.12.2 LED flashing – red
Detected errors are signaled by red flashing codes as follows:
The blink codes are repeated continuously after a pause.
In this case, do the following:
1.
Switch the device off and - after a short pause - on again.
2. Contact the responsible service department if the error
is signaled again.
7.12.3 Establish operation after aborts (e.g. due to power failure)
After an unforeseen failure

e.g. after a power failure, or

after an abort (by switching off),
you can put the pipettor back into operational readiness.
Further information:
→
„Establish operation after abort (e.g. due to power failure)” on
page 48
First make sure that a safe start-up is possible!
7.12.4 Manual axis movement after an abort
The pipetting head can be moved manually in the X direction with little effort. Likewise,
the decks can be moved manually - while the device can be switched on or off. In the Z
direction, the pipetting head can only be moved with the aid of the PC control or in manual
mode (device switched on).
Flashing code Detected error type/comment
once Error on internal motor bus
twice Defect in the E-STOP system
three times Defect in louver monitoring
four times Defect in external E-STOP monitoring
five times Defect in the E-STOP motor current cut-off
six times Defect in the E-STOP motor current cut-off
ten times Data memory version number deviation
eleven times Data memory version number illegible
twelve times Data memory device configuration illegible
thirteen times Data memory
fourteen times Synchronization error