ENCAD NovaJet 4, User Manual

Page: 35 / 200

User's Guide
Getting started 2-35
GETTING S
T
AR
TED
➪ ➪
➪ ➪ ➪
To prime the delivery lines (NJP-36 and NJP-50 only)
1 Press Access Cartridges to move the cartridge carrier out of the service
station.
2 Be sure the tubing clamps are open.
The carriage assembly has four blue tubing clamps on the top which
close and open the ink delivery lines. To close the tubing clamp, press
down on its left side until it snaps under the overhang.
To open the tubing clamp, press the overhang to the left until the tubing
clamp pops up.
3 Remove a 30 cc pump and rubber priming attachment from the NovaInk
tool kit. Two sets are provided; either can be used.
4 Attach the priming attachment to the 30 cc pump.
5 Fully close the plunger on the priming pump.
6 Slide the rubber priming attachment over the delivery needle (Step B in
the illustration that follows).