26534-1-0610
Page 21
%9(17),5(3/$&(6
Model
&RQYHUVLRQ.LW0RGHO
(Part Number)
%9')36(5,(6
%9&.3
%9')36(5,(6
%9&.3
%93)36(5,(6
%9&.3
)25&219(56,2172/,48(),('3(752/(80*$6
WARNING
This conversion kit is to be installed by an Empire Comfort Systems,
,QF GHDOHU RU RWKHU TXDOL¿HG DJHQF\
1
)* in accordance with the
manufacturer's instructions and all codes and requirements of the
authority having jurisdiction. Failure to follow instructions could
UHVXOW LQ VHULRXV LQMXU\ RU SURSHUW\ GDPDJH 7KH TXDOL¿HG DJHQF\
performing this work assumes responsibility for this conversion.
1
National Fuel Gas Code Z223.1 (Latest Edition), Natural Gas and
3URSDQH,QVWDOODWLRQ&RGH&6$%
7KHWHUPTXDOL¿HGDJHQF\PHDQVDQ\LQGLYLGXDO¿UPFRUSRUDWLRQ
or company which either in person or through a representative is
engaged in and is responsible for (a) the installation of gas piping or
(b) the connection, installation repair, or servicing of equipment, who
is experienced in such work, familiar with all precautions required,
and has complied with all the requirements of the authority having
jurisdiction.
V
E
N
T
PI
LO
T
IN
&+(&.6$)(7<6+87'2:13(5)250$1&(
WARNING
Perform the safety shutdown test any time work is done
RQDJDVV\VWHPWRDYRLGWKHSRVVLELOLW\RI¿UHRUH[SORVLRQ
with property damage, personal injury or loss of life.
SAFETY SHUTDOWN SYSTEM
Continuous Ignition Systems
1. Place gas control knob in Pilot position. Main burner should go
off and pilot should remain lit.
([WLQJXLVK SLORW ÀDPH 3LORW JDV ÀRZ VKRXOG VWRS ZLWKLQ
minutes. Safety shutoff of pilot gas proves complete shutdown
VLQFHVDIHW\VKXWRIIYDOYHEORFNVÀRZRIJDVWRPDLQEXUQHUDQG
pilot.
3. Wait 5 minutes, then relight pilot burner and operate system
through one complete cycle to make sure all controls operate
properly.
PARTS LIST
&RQYHUVLRQ.LW
Model
%9&.3
%9&.3
%9&.3
Part
Description
.LW1R
19160
.LW1R
19161
.LW1R
19162
Quantity
Supplied
Fireplace
%9')3
SERIES
%9')3
SERIES
%93)3
SERIES
3LORW2UL¿FH
#35 (R-7658)
#35 (R-7658)
#35 (R-7658)
1
Main Burner
2UL¿FH
P-289
1.35mm
P-208
1.45mm
P-250
1.65mm
1
Dexen 10" w.c.
Regulator
R-7548
R-7548
R-7548
1
Gas Conversion
Label
2139
2139
2139
1
*DVLQSXWIRU%9HQW¿UHSODFHFRQYHUWHGWR/LTXH¿HG
Petroleum Gas:
BVD34FP3 SERIES
21,000 BTU per hour
BVD36FP3 SERIES
25,000 BTU per hour
BVP42FP3 SERIES
30,000 BTU per hour
7KH %9HQW ¿UHSODFH ZKHQ FRQYHUWHG WR /3 *DV ZLOO KDYH
manifold pressure of 10.0" w.c. at the valve outlet with the inlet
pressure to the valve from a minimum of 10.8" w.c., for the purpose
of input adjustment, to a maximum of 14.0" w.c.
,16758&7,216)25&219(56,21
,IWKH¿UHSODFHLVLQVWDOOHGWXUQRIIJDVDQGHOHFWULFVXSSO\
before making the gas conversion.
,GHQWLI\ WKH ¿UHSODFH PRGHO WR EH FRQYHUWHG DQG UHDG DOO
instruction steps prior to converting the gas valve.
3.
Remove all logs from the burner assembly.
4.
Open the sliding valve access door.
5.
Depress and turn the gas cock dial to the "OFF" position.
9$/9(&219(56,21
6.
Remove two (2) screws, regulator, and gasket from gas valve
control body.
7.
Install the new gasket, regulator, and gasket from gas valve
control body.
%851(525,),&(&219(56,217XEHVW\OHEXUQHUV
D 2QPRGHOV%9')3VHULHV¿UHSODFHV\RXZLOOKDYH
D8VKDSHGEXUQHUWXEH7RJDLQDFFHVVWRWKHPDLQRUL¿FH
simply bend over the small retainer tab located at the front
right end of the tube using pliers.
9a. Remove the 1/4" long screw from the air shutter at the left end
of the tube.
10a. Pull up on the back of the burner and rotate forward to gain
DFFHVVWRWKHPDLQRUL¿FH5HPRYHWKHRUL¿FHDQGUHSODFHZLWK
WKH/3RUL¿FHGHVLJQDWHGLQWKHRUL¿FHUHIHUHQFHFKDUW6HFXUH
WKHQHZRUL¿FH
11a. Pivot the burner tube back down in its original position mating
with the air shutter, and reinstall the 1/4" long screw. Set the
air shutter opening in accordance with the dimension shown
LQWKHUHIHUHQFHFKDUWIRUWKHDSSURSULDWHPRGHO¿UHSODFH
STANDING PILOT PROPANE/LP GAS CONVERSION
