EAOM-210 FLJ.eng / ver 0.0
Pages 7 / 132
Section 2 Installation
Before beginning installation of this product, please read the instruction
manual and warnings below carefully.
A visual inspection of this product for possible damage occurred during shipment is
recommended before installation. It is your responsibility to ensure that qualified
mechanical and electrical technicians install this product.
If there is danger of serious accident resulting from a failure or defect in this unit , power
off the system and separate the electrical connection of the device from the system.
Keep the power off until all of the wiring is completed so that electric shock and trouble
with the unit can be prevented.
2.1 Unit Configuration
The unit can be programmed using the buttons and display on the front panel or EAOM-210
FLJ software. Refer to
Section 3 Definition Of Front Panel And Programming
for details.
2.2 Mechanical Installation
The unit is designed for panel mounting. Fixing is by four screw fixings. ( See Figure 2.1)
1.
Insert the unit in the panel cut-out from the front.
2.
Insert the fixings in the slotted at the corners of the unit and tighten the fixing screws
to secure the unit against the panel.
During the equipment is putted in hole on the metal panel while mechanical
installation some metal burrs can cause injury on hands, you must be careful.
1
4
4
m
m
204mm
186mm
1
3
8
m
m
V
HIGH TEMPERATURE
FAILED TO START
LOW OIL PRESSURE
SPEED FAILURE
VOLTAGE FAILURE
CHARGING FAIL
RPM
MAINS
MANUAL
TEST
AUTO
OFF
RESET
TEST
PROG
EAOM - 210 FL
STOP
START
G
ENGINE
RUNNING
LOAD
Figure 2.1 Front view.
Figure 2.2 Panel cut-out