89
Reference Manual
00809-0200-4702, Rev CA
Section 9: Operation and Maintenance: Models 702DX32 and 702DX42
February 2013
Operation and Maintenance: Models 702DX32 and
702DX42
Table 9-1. Variable Mapping
Setting the reported value in AMS Wireless Configurator
The 702 transmitter reports the discrete state of switches wired to the input channels. There are
various pairs of discrete states that correspond to an open or closed input switch. This pair of
discrete states is called the Reported Value and can be set in AMS Wireless Configurator by
going to Configure > Manual Setup > Discrete Channels > Setup Channel X (1 or 2). Under
Reported Value there is a drop down menu of choices. The Reported Value can be set
independently for each of the two channels.
Figure 9-7. Setting the Reported Value
Reported Value:
Table 9-2
gives the Reported Value choices and the names for each possible
state. Also given are the corresponding Analog Value and Discrete Value for each possible state.
Value Name: The Name of the reported value will be seen in AMS Wireless Configurator, and on
the device display. The device display may shorten the Name to fit the available display
segments.
Analog Value: The Analog Value is seen on the Gateway web interface under the PV or SV. This is
also the value that is reported through the Gateway to a control host that requires an analog
floating point value for PV or SV.
Variable Reporting
Variable Mapping
PV
SV
TV
QV
Classic – Discrete State Only
CH1 State
CH2 State
Electronics
Temperature
Supply
Voltage
Enhanced – Discrete State with
Count
CH1 State
CH2 State
CH1 Count
CH2 Count
