Emerson Micro Motion 3711, Configuration And Use Manual, Page: 46 / 234

38 Micro Motion
®
Model 3711 Gas Flow Computers
Configuring the Core Interface
5.3 Using ROCLINK 800 with the Micro Motion core interface
The flowchart in Figure 5-1 displays the recommended procedure for using ROCLINK 800 to
configure the core interface. See Section 2.4.2 for information on the function buttons, and see
Sections 14.2 and 14.3 for information on the saved configuration file and flash memory.
Figure 5-1 Configuration method flowchart
5.4 Core interface configuration panels
This section describes the panels used to configure the core interface.
To access a panel, click the appropriate tab at the top of the Core Processor Interface window.
5.4.1 Mass Flow panel
The Mass Flow panel is shown in Figure 5-2. Parameters on this panel control how the sensor will
measure and report mass flow data to the Model 3711. Parameters are listed and defined in Table 5-1.
Mass Flow / Density /
Temperature
Change parameter on screen
Write parameter
to core processor
Verify change in
Model 3711
Update configuration file
Verify change in
core processor
Configuration
Write to flash memory
Write change
to Model 3711
Apply
Done
Update
Write Config Data
Read Config Data
Save Configuration
File Menu >
Save Configuration
Device Menu >
Flags