Emerson Micro Motion 3711, Configuration And Use Manual, Page: 25 / 234

Configuration and Use Manual 17
System Configuration
Ge
tti
n
g
Sta
rted
Co
mm
uni
cati
on
s
Sy
stem
Be
fo
re
Y
o
u
Begin
Figure 3-2 ROCLINK 800 Security dialog box
2. To add an operator ID:
a. Enter a 1–3 character value in the
Operator ID
column. Any alphanumeric character may
be used. All operator IDs must be unique on this ROCLINK 800 installation. The field is
case-sensitive.
b. Enter a 1–4 character value in the Password column. Only numeric characters may be
used. Passwords do not have to be unique.
c. Enter the access level to be assigned to this operator ID. See Section 3.3.3.
3. When all desired operator IDs have been defined, click
Save
.
Note: You cannot save an operator ID without a password, or a password without an operator ID.
You can save an operator ID and password without an access level.
4. To delete an operator ID, password, or access level, highlight the cell and press Delete , or
backspace over the value.
Note: For security reasons, Micro Motion recommends that the default operator ID be deleted after
appropriate administrative operator IDs have been defined.
3.3.2 Device security
You can enable or disable device security for the LOI and for COM1 and COM2. For each comm
port, you can enable security by operator ID or by access level.
The operator ID and password used to login to ROCLINK 800 will automatically be used for the
Model 3711 login attempt. Therefore, for each ROCLINK 800 operator ID which will be used to
access the Model 3711, define a matching Model 3711 operator ID. Up to 16 Model 3711 operator
IDs may be defined.