Installation
Liebert
®
IntelliSlot
®
Unity
™
Card
6
Static IP
To assign a static IP address, use the Ethernet connection to configure the card. Proceed to
2.1.2 -
Connect an Ethernet Cable
and
2.2 - Change User Names and Passwords Immediately
.
2.1.2 Connect an Ethernet Cable
1. Connect a computer running a Microsoft Windows
operating system (Microsoft Windows
®
XP with
SP2 [64-bit] or SP3 [32-bit] or later) to the card by plugging a network cable into the RJ-45 port on
the computer and the Liebert IntelliSlot Unity card.
2. Autoconfiguration, which is normally enabled on computers running Microsoft Windows
operating systems, will automatically negotiate the communication settings. This takes about one
minute.
3. If the Ethernet adapter being used to attach to the card does not show an Autoconfiguration IPv4
Address, open a new Command Prompt and type
ipconfig/renew
and press Enter. This forces the
computer to acquire an Autoconfiguration IPv4 Address.
4. When the computer has an Autoconfiguration IPv4 Address, open a browser window on the
computer and type
169.254.24.7
(the card’s default Autoconfiguration IPv4 Address) in the URL
address field. The card’s Web page will appear.
Figure 2
Command prompt access
NOTE
If the computer does not automatically connect, verify that autoconfiguration is enabled by:
Open the Command Prompt window from the computer’s Start menu.
Enter ipconfig/all to verify that Autoconfiguration is enabled on the computer and that an
Autoconfiguration IPv4 Address has been assigned: Enabled = Yes (see
Figure 2
). An
Autoconfiguration IPv4 Address begins with 169.254.)
Last
DHCP
Address
Support>Active Networking
Unity Tab
