Enable Communication Protocols
17
Liebert
®
IntelliSlot
®
Unity
™
Card
Figure 11 SNMP settings
Configure SNMP Settings
SNMPv3 Users or SNMPv1/v2c Trap and Access settings must be made before SNMP access or
notifications can occur. The Liebert IntelliSlot Unity card permits up to 20 SNMPv3 Users, up to 20
SNMPv1 Trap targets, and up to 20 SNMPv1/v2c Access addresses.
The required changes vary according to the type of SNMP protocol used. For SNMPv1, trap settings
must be made. SNMPv2c must have Access Settings made. SMPv3 users must have settings
configured. SNMPv1 trap settings are separate from the access settings for SNMPv1/v2c.
Configure SNMPv3 Settings
The settings must be made for each user who will receive notifications.
1. Select Unity Tab > Protocols > SNMP > SNMPv3 Users Setting (20) > SNMPv3 Users Setting (1).
2. Click on
Edit
and enter a User name and password if required.
3. Enter the information and set the permissions appropriate to the user. Refer to
Figure 12
for the
information required.
4. Click
Save
to confirm the changes or click on
Cancel
to discard them.
5. Repeat
Steps 1
through
4
for any additional users.
6. Restart the card to activate the changes.
a. Select the Unity Tab > Support.
b. Enable the commands.
c. Click on
Restart
.
