20
Initial start-up
Procedure
Carefully read through the recommendations for commissioning and for
configuring the wireless connections for the individual devices.
Bringing a device from a cold room into a warm room can cause
a build-up of condensation. Before commissioning, ensure that
there is no humidity in the device (leave to dry if necessary).
After checking all connections, switch on the mains voltage to the motor control
units (and to the weather stations if necessary). If a Solexa or Arexa control
system is used in the XS system, commission this first (including basic settings).
Then configure the wireless connections between the installed devices of the XS
systems (and the weather station if necessary) and apply the basic settings for
the drives on the XS 1B-D control unit.
Configuring and deleting wireless connections
Wireless connections may only be configured by a professional
electrician, as the button for configuring and deleting these is
located inside the housing.
The wireless connections between the individual components of the XS system
are configured using the programming and/or configure/delete buttons (motor
control unit, weather station) and the operation buttons (control unit).
In order to configure a wireless connection, the XS MSG2-AP motor control unit
(and if necessary the Solexa/Arexa weather station) must be installed, supplied
with voltage, and the housing opened. The control units must be fitted with
charged batteries.
Close and tighten the screws of the cover of the motor control unit after
configuring the wireless connections.
Pressing the configure/delete buttons on the XS MSG2-AP motor control unit
housing allows you to access the configure/delete mode for the different
devices:
Press briefly once (both LEDs are on): Solexa or Arexa weather station
Press briefly twice (both LEDs flash): XS 2B double control unit
