32
If you make any changes here (switching from individual
automation to parallel control, or vice-versa), please skip the
following step, "4. Operating position" using
and then
save your settings as shown in „5. Saving your basic settings".
To set an operating position, you should once again enter the
basic settings area and configure the operating position.
4. Operating position
After setting the drive type (individual or parallel operation) comes the next step,
"Configuring operating positions".
For awnings and blinds (Solexa), individual positions can be set up to which the
shades are extended in Automatic mode. For venetian blinds, the opening angle
of the slats can also be set (reversing).
For windows (Arexa), individual positions can be set up to which the automation
opens them.
Press the
button until the desired screen appears:
(Continue) to skip setting operating positions. The shade will then
fully extend (close) using the automatic process, and the window
will open fully. In this event, proceed as described in chapter "5.
Saving your basic settings".
(Learn) to configure an operating position.
(Clear, Delete) to delete an existing configured operating position.
The shade will then once again fully extend (close) using the
automatic process, and the window will open fully. In this event,
proceed as described in the chapter "5. Saving your basic settings".
Confirm your selection using the
button.