ELCOM Euro-100T, User Manual

Page: 20 / 84

20
Cash register characteristics
Switching into the “T” mode:

„STANDBY“ When the cash register is not operated
for certain time limit (see chap. System flags program-
ming) and it is supplied from internal power supply, it
will switch into the “Standby” mode. A cash register in
the “Standby” mode has a low consumption of energy.
The notification “Standby” appears on the display.
Exit the “STANDBY” mode by pressing the

(Mode) button. In case the cash-register is supplied from
external power supply then stand by mode is not called.
PAPER RIBBONS INSTALATION
The Euro-100T cash register uses two thermal paper ribbons, 28 mm wide. The left one (a front view on the
cash register, see the picture below) is designed for the printing of customer receipts and the right one for
the printing of the control ribbon - journal.
Figure 2.7 - Paper ribbons installation procedure for Euro-100T:
We recommend to use only rolls of good quality paper with the maximum diameter of 55 mm. To ensure
proper cash register operation, make sure that the printing saturation is correct. If any problems occur,
contact your local authorized dealer of Euro-100T.
Paper ribbons installation procedure for Euro-100T (numbers according to Figure 2.7):
Open the tape cover (1), follow the picture below. Take out the paper tape separator (4) and install new
paper tape reel. Insert the separator with installed tapes into the bottom cover (3). Use the lever (10) to rele-
ase the printer roller and lift it up. Hold the ends of the ribbons over the upper cover (2), press the roller on
the original place and press the paper feed button (9) make sure that paper ribbons are installed properly.
Close the tape cover (1).
tape cover (1)
journal ribbon (6)
tape separator (4)
customer ribbon (5)
the printer roller (8)
the winding reel (7)
the paper feed button (9)
upper cover (2)
bottom cover (3)
the lever to release
of the printer roller (10)


