ELCOM Euro-100T, User Manual

Page: 32 / 84

32
Programming manual
6) Finish the programming of cashier’s password by pressing

(S
UBTOTAL
) key. The ECR will then
show the current cashier number at the display along with label (“
CASH.฀ACCE
”) that indica-
tes programming of cashier’s access rights for ECR modes. Press

(T
OTAL
) to finish the entire
programming procedure (next steps will not run).
7) Program the mode access flags according to the Figure 3.14. If you mistype, correct your mistakes
using

(C
LEAR
) key. Warning: you cannot deny access to programming mode “P” for the cashier
no. 1.
Figure 3.14. Cashier access rights.
Digit Meaning Valid values
1 Access to the “X” mode
0–no, 1–yes
2 Access to the “Z” mode
3 Access to the “P” mode
4 Access to the “T” mode
8) Press the

(S
UBTOTAL
) key to continue programming of the remaining cashiers; continue with step
3. If you press

(T
OTAL
) key, you finish the programming procedure for the cashiers.
Correction of cashiers values
1) Switch the ECR to the “P” mode by pressing

.
2) Enter the number of the cashier you wish to correct and press

(P
ASSWORD
) key.
3) Continue in the same way as shown in section above.
4) You can print out data of all cashiers by pressing

(C
HECK
) key; press

key to print out data of
the current cashier only.
5) Finish the corrections by pressing

(T
OTAL
) key.
Printing of cashiers values
To check the programmed names and other settings, press the

(C
HECK
) key in the cashier program-
ming. In the programming mode, press the

(P
ASSWORD
) key first and then press

(C
HECK
) key. Print
the programmed values of the current cashier by pressing the

(EAN) key.
FUNCTION TEXTS PROGRAMMING
The Euro-100T allows you to program all the operation labels that can be displayed/printed to the receipt.
The default values for all function texts are shown in the Figure 3.15. You can adjust all of them to your
needs.
Function texts programming procedure:
1) Switch the ECR to the “P” mode by pressing

.
2) Press the

(V
OID
) key. ECR will display the number of the currently programmed function text
and then contents of that text.

.


.




