ECKELMANN VS 300, Operating Instructions Manual

Page: 162 / 172

Alarms and Messages of VS 300
154 Doku-Version 2.05 - Firmware 2.10 - 15. September 2017
10.3 Messages / alarms in the VS 300
Z
N
R
.
51203
50
9
30
E S C
RE S ET
1 2 3 4
1 2
5 6 8
9 1 0 11 12
7
S tatus
1 2
O FF
/ /
O FF
(2)
Message/alarm code shown on display - process fault report E212 in this example
These message/alarm codes can be displayed in more detail by opening Parameter List F on the integral user
interface. Faults and messages/alarms occurring are displayed in two ways:
1. In basic display mode: The respectively most recent message is indicated in basic display mode by its
associate fault code ( E001
−
E246 , see section NO TAG Process Fault Reports or System Fault Reports
for details). The alarm/message LED flashes. Pressing the ESC/RESET key quit the display and returns to
displaying control loop actual temperature. When the message is no longer current or when no more faults
are effective, press the ESC/RESET (longer than 5 sec.) to cancel the message and delete it from the fault
report memory.
2. In message display mode: From Parameter List F you can change to message display mode. On press­
ing the
↵
key while in Parameter List F, F001 is displayed if a message is current, meaning not yet can­
celled. This indicates the most recent message. Use the
↑
key to move to the preceding messages ( F002
to max.
F100
). If no messages exist, '- - - -' is shown on the display.
Messages/alarms that are still active are shown flashing to distinguish them from inactive messages/
alarms.
Pressing the
↵
key again in message/alarm display mode ( F002 - max. F100 ) displays details for the se­
lected message/alarm. Message/alarm details consist of the message/alarm code ( E001 - E246 , see sec­
tion 8 Process Fault Reports and System Fault Reports for details), message/alarm status ( 0 or 1 ), incom­
ing time stamp (date-year-time) and outgoing time stamp (date-year-time).
These message/alarm details can be interrogated with the
↑
and
↓
keys. The relay/control stage status
LEDs indicate which message/alarm detail is currently displayed. For example, the day date (15th) of the
incoming time stamp is shown in the illustration above.