EC-PACK EC-JET 2000, Manual

Page: 74 / 107

User Manual The1.1 version of 2018 Guangzhou EC-PACK CO.LTD
74
If the solvent low condition is detected before the jet is started, then the jet cannot be started until
the solvent tank is replenished.
If the condition is detected while the jet is running, the jet will continue to run regardless, but no
attempt will be made to add solvent.
9.4.6. 3.05 Print Go/ Remote Data
A “print go” has occurred and printing data has not been received from the remote interface.
Make sure the transmission cable and the port are right setting.
9.4.7. 3.06 Service Time
When the jet is started, the time remaining to the next service is checked. If it exceeds 4000 hours
then this warning is reported and the jet is started as normal.
This warning will be reported on every jet start up until the service time has been reset.
Maintenance should be made when there is warning, otherwise it will affect the machine
performance and stability.
9.4.8. 3.07 Print Head Cover Off
This warning is reported if the print head cover is removed.
The supply to the EHT plates is switched off (by hardware) when the cover is removed.
WARNING: THERE IS A LINK WHICH, WHEN FITTED, DISABLES THIS
AUTOMATIC SHUT OFF. THEREFORE, THE PRESENCE OF THIS
WARNING IS NOT A GUARANTEE THAT THE EHT IS OFF.
Printing is suspended when the cover is removed and is resumed a few seconds after the cover is
refitted.
The warning supplies to the currently printing pattern - it is reset automatically when printing is
restarted.
9.4.9. 3.08 Print Head Not Fitted
At start up the software checks the type of print of print head that is fitted. If it does not recognize
the print head type this warning is reported.
The system will continue to operate on the assumption that the print head has not been changed,
and will continue with the same print head type as used previously (i.e. the currently stored NVR
print head type).
If a new type of print head has been fitted, but has not been detected correctly, the modulation
frequency, voltage, etc., will all be incorrect. Therefore, the jet will not break up properly, and a
phase fault (2.02) will probably occur when starting the jet.
9.4.10. 3.09 New Print Head Fitted
At start up the software checks the type of print head fitted. The last print head type used is stored
in the printer is memory.
If the currently fitted type is not the same as the type stored in memory then this error is reported
and the type in memory is updated.
This warning should only ever occur when a new print head is fitted. If it occurs at other times