EC-PACK EC-JET 2000, Manual

Page: 73 / 107

User Manual The1.1 version of 2018 Guangzhou EC-PACK CO.LTD
73
Allow the printer to run to bring the viscosity back into range.
●
There is a pressure loss in the system.
Contact your local EC-JET distributor.
9.4.2. 3.01 Jet Shut Down Incomplete
This indicates that the printer was previously switched off while the jet was running or before the
printer had completed the shutdown routine. Completion of the shutdown routine is important and
must be allowed to finish.
The warning does not stop the printer from functioning. It will be reported at every subsequent
printer start-up until a jet shutdown routing is fully completed. Press the key and wait for
the message.
“
Jet Off
”
9.4.3. 3.02 Over Speed (Print Go)
This indicated that the printer may have missed printing at least one pattern or is receiving false
triggers from the photocell.
When the Photocell Mode is set to Trigger, each print delay is started following the photocell
trigger.
At the end of the delay a “print go” is issued to start printing. If the printer has not printed the last
pattern by this time, the warning is reported and the new pattern is not printed. In effect, this will
mean that alternate objects will NOT be printed on.
The warning applies to the current printing is reset automatically when printing is restarted.
Possible cause
●
The next object has arrived at the print head before the last pattern is complete because:
1. The line speed is too fast.
2. The pattern is too long compared to size of the objects to be printed on.
●
The photocell is giving false triggers.
9.4.4. 3.03 Ink Low
If the ink level sensor indicates that the ink reservoir is low then this warning is given. It is cleared
automatically when a sufficient amount of ink is added.
Do NOT put in more than one bottle(500ml) each time.
If the ink low condition is detected before the jet is started, then the jet cannot be started until the
ink tank is replenished.
If the condition is detected while the jet is running, the jet will continue to run for several hours
until the ink is dangerously low, at which point a failure will occur (see Print Failure “2.06”).
9.4.5. 3.04 Solvent Low
If the solvent level sensor indicates that the solvent reservoir is low, then this warning is given. It
is cleared automatically when a sufficient amount of solvent is added to the reservoir.
Do NOT put in more than one bottle (500ml) each time.