142
Typ EP 501
Auxiliary functions
Specifying.interval.for.the.output.of.messages
Key
Action
Description
/
Select
TRAVEL.ACCU
(To do this, the
TRAVEL.ACCU
function must be incorporated into
the
DIAGNOSE
main menu. See Chapter “24.2.22.4. Activation of
ENTER
Press
The menu is displayed.
* Required for analog position sensor only (setting the
STROKE
submenu)
/
*
Select
STROKE
INPUT
*
Press
The preset value is displayed.
/
*
Increase value
<
Changing the decimal
place
Set total stroke of the actuator piston.
/
Select
LIMIT
INPUT
Press
The preset value is displayed.
/
Increase value
<
Changing the decimal
place
Setting interval for outputting the message (limit for total number of
piston movements).
OK
Press
Return to the
TRAVEL.ACCU
menu.
EXIT
Press
Return to the
DIAGNOSE
main menu.
Table 78:
TRAVEL.ACCU; specifying interval.
CYCLE.COUNTER
–.Direction.reversal.counter
The direction reversal counter counts the number of changes in direction of the actuator piston. A change in direction
is detected when the position of the actuator piston changes by at least 1 %.
The interval for outputting messages is specified by inputting a limit for the total number of changes in direction.
• To do this, a history entry is made in the
HISTORY
submenu. For description see “24.2.22.7. History entries in
• The status signal, which is assigned to the message, is indicated at short intervals on the display.
See also
D.MSG
and
CONFIG.MSG
in Chapter “24.2.22.5”, page 133.
Display.
CYCLE.COUNTER
Description.of.the.functions
EXIT
INPUT
29-7-1
CYCLE.COUNTER
LIMIT
HISTORY
NEXT.M
999960
1000000
The interval for outputting the message can be changed in the
LIMIT
submenu. 1 million changes in direction have been preset at the factory.
After
NEXT.M
the remaining changes in direction are displayed until the
next message appears.
The history entries of the last 3 messages can be viewed and deleted in
the
HISTORY
submenu.
Table 79:
SERVICE.TIME; operating-hours counter
english