Eaton Power Xpert 9395 UPS, Installation And Operation Manual

Page: 67 / 250

UPS System Installation
Power Xpert
TM
9395 UPS (450–825 kVA) Installation and Operation Manual 164201725—Rev 10 www.eaton.com/powerquality 4-7
Figure 4-6. Removing the Two UPM Section Right Side Shipping Bracket
4.3 Mechanically Joining the Sections
1. Unfasten the front door latch and swing the door open (see Figure 4-1).
2. Remove one top screw and two bottom screws securing the UPM section wireway panel (see Figure 4-7).
Lift the panel straight up to remove it from the panel hanger brackets at the top of the cabinet.
3. Remove the screws securing the top and bottom internal safety shield panels and remove the panels.
Retain the hardware for later use.
4. Remove the screws securing the corner channel and remove the channel (see Figure 4-7). Retain the
hardware for later use.
Shipping Bracket
Bolts
Shipping Bracket
Bolts
Pallet
Right Side Shipping
Bracket
NOTE The following procedure permits the UPS sections to be installed in a location
where there is limited space to slide the sections together from the sides.
NOTE For the following steps, verify that the forklift or pallet jack is rated to handle the
weight of the section (see Table 3-1 for cabinet weight).