Eaton Power Xpert 9395 UPS, Installation And Operation Manual

Page: 106 / 250

Installing Options and Accessories
5-2 Power Xpert
TM
9395 UPS (450–825 kVA) Installation and Operation Manual 164201725—Rev 10 www.eaton.com/powerquality
5.2 Installing an Optional Powerware Hot Sync CAN Bridge Card
As an option, a Powerware Hot Sync Controller Area Network (CAN) Bridge Card, shown in Figure 5-1, can be
installed to provide connectivity for operational mode control of a parallel system. In addition, this card can be
used to connect optional system monitoring devices, such as a Remote Monitor Panel II, a Relay Interface
Module II, or a Supervisory Contact Module II to the UPS.
Figure 5-1. Powerware Hot Sync CAN Bridge Card.
To install the card:
1. Verify the UPS system is turned off and all power sources are removed. See Chapter 7, “UPS Operating
Instructions” for shutdown instructions.
2. Unfasten the front door latch and swing the door open (see Figure 4-1).
3. Install the Powerware Hot Sync CAN Bridge Card into an open X-Slot communication bay on the front of
the UPS. See Figure 4-24 and Figure 4-30 for X-Slot communication bay locations.
To locate the appropriate terminals on the Powerware Hot Sync CAN Bridge Card, see Figure 5-2 and
Table 5-1.
NOTE Only one Powerware Hot Sync CAN Bridge Card can be installed in the UPS.
Multiple CAN cards are not supported and will cause system conflicts.
Plug-in Terminal
Block J3