Eaton LINX, Installation Manual

Page: 90 / 123

O r g a n i z e r O v e r h e a d
S h e l f
Tools Required
-5/32” Allen wrench (provided)
-7/16” Wrench
-Plastic mallet
NOTE : The Shelf is shipped with four shoulder screws
installed in the bottom surface. Be careful not
to damage other surfaces after unpacking.
1. Remove the
Top Cap from each of the Organizer
uprights. See Figure 1 .
2. Install a
Plastic Grommet into each of the two
square holes inside the top of each upright. See
Figure 1 .
3. Insert a
Spacer into the top of each upright with the
offset bends toward the inside. See Figure 2 .
Assemble the
Left and Right hand Shelf Supports
onto the top of each upright by placing them over the
Spacers and securing them with the 1/4”-20 x 3.50”
Lag screws and washers provided.
DO NOT tighten
at this time. IMPORTANT : Be sure to install the
Shelf Supports with the mounting clips facing up.
See
Figure 2 . See note below before tightening the
screws.
NOTE : To provide side clearance for the Locking
Compartment door, the Shelf Supports are
.10”(2,5mm) narrower than the uprights to
which they are mounted. See
Figure 3 .
Align the outer surfaces of the Shelf Supports with
the outer surfaces of the uprights and tighten the lag
screws until they just bottom out.
DO NOT OVER-
TIGHTEN .
Organizer Overhead Shelf
Figure 1
Plastic grommet
Square hole
Upright
Top cap
Locking compartment
Figure 2
Upright
1/4”-20 x 3/1/2” Lag
screw
Washer
Mounting clip
Shelf support
(L.H. shown)
Spacer
Locking compartment
Figure 3
Shelf support
Upright
.10”(2,5mm) Gap
82247
technical furniture
D-23