Eaton LINX, Installation Manual

Page: 27 / 123

Tools Required
-Phillips head screwdriver
-Electric drill
-1/8” Drill bit
NOTE : The Peninsula is provided with the Top Con-
nection Bracket/Stiffener and the die cast Leg
Mounting Plate factory installed.
The height adjustable Leg provides the ability
to install the Peninsula to a 29” to 30” high
Worksurface.
1. Remove the
Peninsula from the carton and place it
carefully, finish side down, on a smooth clean sur-
face.
2. Attach the
Tubular Leg to the worksurface. Align the
holes in the mounting plate with the appropriate holes
in the worksurface and secure using the five #10AB x
1.00” Pan head self tapping screws provided. See
Figure 1 .
3. With two people, turn the Peninsula upright and place
it in position against the Worksurface it will be attach-
ed to. See
Figure 2 .
4. Next, select two holes in the Connection Bracket, one
on each side near the center. Using them as a guide,
drill holes
1/2” deep into the underside of the Work-
surface and install two screws. Drill the remaining ten
holes and install the screws. See
Figure 2 .
5. Install a
Tie Plate on each side of the Peninsula. Using
the Tie Plates as guides, drill 1/2” deep holes and at-
tach them with the screws. See Figure 2 .
Peninsula, Top Connection
Figure 1
80752
P e n i n s u l a , T o p
C o n n e c t i o n
technical furniture
A-21
Figure 2
Peninsula
Tie plate
Flush
#10 x 3/4” Phillips
head screws
Worksurface
Tubular leg
Leveler
Top connection
bracket/stiffener
Peninsula
#10AB x 1.00 pan head
self tapping screws
Pre-drilled holes