Eaton LINX, Installation Manual

Page: 31 / 123

SELECTING A LOCATION
Positioning the Posting Shelf to the extreme left or right
is recommended for all Workstations.
On 24” deep surfaces, the cable port will be blocked
when in the extreme position. You may wish to move in
2” to clear it.
Hook-on surfaces (LMS), 72” in length, have a formed
stiffener on their underside. The posting shelf mounts
on the stiffener.
NOTE: There are 4 mounting holes on each side. In
some situations, all the holes will not be used. On the
24” deep surface, if the cable port is covered, wou1d be
one example and the 72” LMS Hook-on is another.
1. Once your location has been selected, position the
posting shelf by aligning its front with the front of the
worksurface and the side with the leg’s top support.
Mark the holes and drill
no more than 3/4” deep .
1A. For LMS 72” Surfaces, align the fronts as above,
but align the side with the end of the stiffener. Mark the
hole locations and drill 5/32” holes (6). Allow the drill
to just penetrate the wood surface. The 3/4” long screws
will also penetrate the wood, but just breaking the hard
wood surface with the drill will suffice.
2. Attach it with the #10 x 3/4” Sheet Metal Screws
provided.
The Tray may be removed from the slide by backing out
the two button head screws on the bottom that are the
extension stops. It will be necessary to angle one rear
corner out at a time. The same is true for re-assembly.
Figure 1
Posting shelf
Worksurface
#10 x 3/4”
Sheet metal screws
Top support
Top support
Cable port
Cable port
C855MM
Posting Shelf
Tools Required
-Powered Drill (with #33 drill bit)
-Phillips Screw Driver
84085
P o s t i n g S h e l f
technical furniture
A-24