Eaton LINX, Installation Manual

Page: 101 / 123

T e c h O r g a n i z e r
Tools Required
-#33 (.113 dia.) Drill (Jobbers length)
-Electric drill
-Phillips head screwdriver
-Plastic mallet
The
TechOrganizer can be installed on Linx
Worksurfaces or appropriate industrial work benches.
Linx Worksurfaces with full depth uprights are
recommended to provide a Workstation/Organizer
with greatest stability.
Important Safety Instructions
* The Organizer must be properly secured to the Work-
surface prior to installing of components.
* Frame load capacity is 300 lbs. (Linx Worksurfaces)
and 400 lbs. (Workbenches).
* Do not install shelves that are greater than 18” deep.
* Do not install shelves more than 35” above the Work-
surface.
1. Position the TechOrganizer in the desired location
on the back of the Worksurface. On a Linx Worksur-
face, locate the back of the frame .20” from the back
edge of the Worksurface. See
Figure 1 .
2. Using the holes in the frame bottom crossbar and the
holes in the feet as a template, locate and drill the
appropriate quantity of .113 dia. holes .50” deep in
the Worksurface. See
Figure 1 .
NOTE : If the feet are not 90° to the frame, tap the
ends with a plastic mallet to correct.
3. Attach the frame bottom crossbar to the worksurface
using the #10AB x 2.25” Phillips head flat head screws
(provided). See
Figure 1 .
4. Attach the feet to the Worksurface using the four
#10AB x .75 Phillips pan head screws (provided).
See
Figure 1 .
85030
technical furniture
E-1
TechOrganizer
Figure 1
.20”
Linx worksurface
(with full depth uprights)
TechOrganizer
frame
Foot
Foot
#10AB x .75” Phillips
pan head screws
#10AB x 2.25” Phillips
flat head screws
Bottom crossbar