Eaton LINX, Installation Manual

Page: 75 / 123

80954LX
TASK LIGHT INSTALLATION
24” TASK LIGHT
The
24” Task Light is installed under the Shelf
either at the extreme left, extreme right, or the center
position. If desired, two 24” Task Lights may be in-
stalled, with one at the extreme left and one at the ex-
treme right.
1. Locate any two screw holes in the Shelf stiffener that
are 16” apart. Install two #10 x 3/8” Phillips head sheet
metal screws partially into the holes, leaving them pro-
truding approximately 1/16”. See
Figure 7 .
Figure 7
“key hole” slot
#10 Phillips head screws
(back out 1/16”)
Shelf stiffener
Cord clip
Cord
Task Light
#W159-X3, #W160-X3
#W165-X3, #W168-X3
2. Remove the lens and bulb from the Task Light .
To remove the lens, push it up near the front edge
of the Task Light fixture. See
Figure 8 . Remove
bulb by rotating it in either direction and then pull-
ing it away from the mounting sockets.
3. Position the Task Light fixture against the Shelf
stiffener with the mounting screws protruding thru
the large ends of the “key hole” slots. Push the fix-
ture toward the back of the Shelf to seat the screws
into the narrow portion of the slots and then tighten
the screws.
4. Now replace the bulb and the lens. The corrugated
surface of the lens is toward the bulb. See
Figure 9 .
Cable Clips are provided to route and secure the
Task Light cord.
NOTE : Fixture must be plugged into a three prong-
ed grounded outlet.
Figure 8. Removing lens and bulb
Figure 9. Replacing lens and bulb
Push here
Task light housing
Lens
Bulb
Mounting socket
Push here
first
Corrugated surface
L o c k i n g
C o m p a r t m e n t s
( c o n t . )
technical furniture
D-8