Eaton LINX, Installation Manual

Page: 23 / 123

3. The
Modesty Panel is installed from the rear and
fits between the Top Supports and the Legs. Fasten
it with four 1/4”-20 x 3/4” Phillips head screws.
Tighten all screws. See
Figure 4 .
NOTE : If the 26” Modesty Panel is being installed,
use six 1/4”-20 x 3/4” Phillips head screws.
4. Remove the
Peninsula Worksurface from the carton
and place it carefully , finish side down, on a smooth
clean surface.
5. Attach the
Tubular Leg to the worksurface. Align the
holes in the mounting plate with the appropriate holes
in the worksurface and secure using the five #10AB x
1.00” Pan head self tapping screws provided. See
Figure 5 .
6. With two people, turn the Peninsula Worksurface upright
and place it onto the Leg/Modesty panel assembly and
fasten it in place with ten #10 x 3/4” Phillips head screws
as shown in
Figure 6 .
7. Level the Peninsula as required by adjusting the levelers
on the feet and Tubular Leg.
8. Install
Tie Plates as shown in Figure 2 .
84913
Figure 4
Figure 7
Figure 6
Leg/Modesty panel
assembly
#10 x 3/4” Phillips
head screws
Peninsula worksurface
Top support
12”/26” Modesty
panel
1/4”-20 x 3/4” Phillips
head screws
P e n i n s u l a , B o l t - o n
( c o n t . )
technical furniture
A-18
Tie plates
#10 x 3/4” Phillips
head screws
Leveler
Figure 5
Peninsula worksurface
Tubular leg
#10AB x 1.00 pan head
self tapping screws
Pre-drilled holes