Eaton LINX, Installation Manual

Page: 25 / 123

P e n n i n s u l a , L i n k e d
84569
Tools Required
-5/32” Hex key (provided)
-1/4” Hex key (provided)
-Phillips head screwdriver
NOTE : The Peninsula Worksurface may be installed
on either the left or right side of a 29” high
LINX worksurface.
These instructions show the Peninsula being
installed on the left side.
1. Assemble a
Top Support to the leg using one 1/4”-
20 x 3/4” Phillips head screw. Do not fully tight-
ten the screw at this time. See Figure 1 .
2. The
Modesty Panel is installed from the rear and
fits between the Top Support and the leg. Attach it
with two 1/4”-20 x 3/4” Phillips head screws.
Tighten all screws securely. See
Figure 2 .
NOTE : If the 26” Modesty Panel is being installed,
use three 1/4”-20 x 3/4” Phillips head
screws.
4. Remove the top two plastic hole plugs from the
adjoining LINX workstation and install the remain-
ing Top Support using one 1/4”-20 x 3/4” Phillips
head screw.
Do not fully tighten at this time. See
Figure 3 .
Linked Peninsula Worksurface
Figure 1
Figure 2
Figure 3
Top support
Leg
1/4”-20 x 3/4” Phillips
head screw
Top support
12” or 26” High
Modesty panel
1/4”-20 x 3/4” Phillips
head screws
Top support
Hole plugs
1/4”-20 x 3/4 Phillips
head screw
Adjoining workstation
Leg
technical furniture
A-19