Eaton LINX, Installation Manual

Page: 18 / 123

T r i a n g u l a r
C o n n e c t o r ( c o n t . )
4. Align the two workstations in their approximate final
positions. With the Modesty Panel installed, position
the Triangular Connector in place.
5. Engage the side flanges on the Modesty Panel with the
extended 1/4”-20 x 1/2” button head screws in the lower
rear section of each leg.
Do not tighten at this time. See
Figure 3 .
6. Fasten the Triangular Connector to each Top Support
using three #10AB x .75 Phillips head screws on each
side. With a second person holding the workstations
and Connector in place, tighten all of the screws. See
Figure 3 .
7. Attach the
Tie Bar to the front of the workstations.
Using the Tie Bar as a template, drill two 1/8” diameter
holes approximately 1/2” deep in the bottom surfaces
of the two adjacent workstation tops. See
Figure 4 .
Fasten the Tie Bar to the tops using the #10 x 3/4” long
screws provided. See
Figure 4 .
Figure 3
Figure 4
Tie bar
#10 x 3/4” Phillips
head screws
Workstation
Triangular connector
84571
Triangular
connector
Side flange
Full depth modesty
panel
#10AB x .75 Phillips
head screws
Top support
Extended 1/4”-20 x 1/2”
button head cap screw
Standard
modesty panel
technical furniture
A-14