Eaton LINX, Installation Manual

Page: 73 / 123

80954LX
TOP PANEL INSTALLATION
1. Be sure the three screws along the top edge of each End
Panel are backed out 1/8” as shown in
Figure 4 .
2. Position the Top Panel above the screws. The Receding
Door mounting holes must face foward. Lower the Top
Panel onto the screws so that the six screws engage their
corresponding slots in the Top Panel. See
Figure 3 .
3. Now tighten the screws to secure the Top Panels to the
End Panels.
4. Apply the
Rubber Bumpers to each end of the Shelf as
shown in Figure 4 .
L o c k i n g
C o m p a r t m e n t s
( c o n t . )
technical furniture
CENTER PANEL INSTALLATION
(66” and 72” Locking Compartment)
The Locking Compartments for the 66” and 72” Organizers
require a
Center Panel to support the two Top Panel and
Receding Door assemblies.
1. Locate the Center Panel over the center of the shelf and
hook the Rear Bracket into the top slot on the Back Panel
as shown in
Figure 3 .
2. Position the Center Panel over the three 1/4” diameter
holes located in the center of the Shelf and fasten it to the
Shelf with the three #10 x 3/4” screws provided.
Do not
tighten them at this time. See Figure 3 .
D-6
Figure 3
Factory installed
screws
Center panel
Holes in shelf
center
Rear bracket
Back panel
#10 x 3/4” Screws
Receeding door
mounting holes
Top panel
Shelf
Figure 4
Rubber
bumper
Factory installed
screws
Slot