Web Interface Operation
Eaton ePDU G3 Operation Manual P-164000277—Rev 1
www.eaton.com/ePDU
110
6.
In the Syslog Server Settings dialog, enable or disable the selected server from the Enable Server
drop-down list. You can also change the following:
l
the port number and the protocol selection to either UDP or TCP from the Protocol drop-down list
l
the message transfer method according to:
- 5424: Syslog Protocol IETF
- 5425: TLS
- 5426: Transfer over UDP
- 6587: Transfer over TCP
- 3167: Syslog protocol IETF (obsolete)
l
the facility code used for all messages from 1 to 23
l
the use of unicode byte order mask (BOM) according to RFC 5424
7.
When you finish modifying Syslog server settings, click
Save
or
Cancel
.
8.
(Optional). Click
Test
to test the configuration.
Access Accounts
Configure the SuperUser
1.
Access the Web interface and log in.
2.
Under Settings, select Access Accounts. The Access Accounts page displays.
3.
In the Admin Access panel, perform the following:
l
Type the SuperUser login.
l
Type the SuperUser password.
l
Type the SuperUser password again.
4.
Click
Save
.
Configure the E-mail Notification Settings
NOTE 1
By default, an e-mail address is attached to each account.
NOTE 2
Any user can change his own e-mail address.
1.
Access the Web interface and log in.
2.
Under Settings, select Access Accounts. The Access Accounts page displays.
3.
In the Admin Access panel, click the e-mail address link.
4.
The e-mail recipient address displays. If needed, change the address.
5.
If needed, type the descriptive text to identify the e-mail receiver.
6.
Enable or disable the e-mail receiver in the status drop-down list.
7.
Check the Attached Files check box to attach the event log file to the e-mail sent to this receiver, or
uncheck the box to send the e-mail without the event log file.
8.
Select the date of the next report using the date picker or manually enter the date in mm/dd/yyyy format.
9.
Set the frequency of the report if this recipient should receive regular reports.