Eagle ICA-D212-725, Instructions Manual

Page: 548 / 729

ICA-D212-725 (71)
Page 17 of 28
CHAPTER 71 – POWER PLANT SYSTEM (71-00-00)

COPYRIGHT

2007 BY DART AEROSPACE LTD.

THIS DOCUMENT IS PRIVATE AND CONFIDENTIAL AND IS SUPPLIED ON THE EXPRESS CONDITION THAT IT IS NOT TO BE USED FOR ANY PURPOSE OR COPIED OR COMMUNICATED TO ANY
OTHER PERSON WITHOUT WRITTEN PERMISSION FROM DART AEROSPACE LTD.
Revision: 5
Date: 12.06.20
71.2.3.3
Installation – Engine Intake
Fairing
71.2.3.3.1
Position intake fairing (3, Figure
71-9) on transmission and engine cowling.
71.2.3.3.2
Align and secure fasteners
around top of fairing and bottom of side louvers.
71.2.4 Transmission Cowling
A one-piece transmission cowling covering the
front and sides of the upper transmission area is
secured by three latches and a hinge assembly.
For access, the unlatched cowling can be swung
forward to rest on cabin roof.
71.2.4.1 Removal – Transmission
Cowling
71.2.4.1.1
Disengage three latches and
swing cowling to the open position.
71.2.4.1.2
Detach hinge from two fittings on
cabin roof by removing bolts with nuts and
washers. Lift off cowling assembly. If hinge is
detached from cowling, observe position of
washers used for alignment for reassembly in the
same manner.
71.2.4.2 Inspection – Transmission
Cowling
71.2.4.2.1
Inspect cowling for dents, cracks
or damage.
71.2.4.2.2
Inspect hinge and fittings for
wear, damage, and serviceability.
71.2.4.3 Installation – Transmission
Cowling
71.2.4.3.1
Position cowling hinge to fittings
on cabin roof and install bolts with washers and
nuts.
71.2.4.3.2 Swing cowling to closed
position. Check alignment for secure latching
and for clearance with control linkages or other
parts on transmission pylon.
71.2.4.4 Transmission and Engine
Cowling Adjustment
Adjustment of serrated hinges and adjustable
rod ends should be accomplished with care and
in such a manner that the cowling is not
deformed.
71.2.5 Tailpipe Fairing
A three-piece fairing covers exhaust tailpipe
area behind engine rear firewall, and is secured
by cowl fasteners. An anti-collision light is
mounted on top of upper fairing.
71.2.5.1 Removal – Tailpipe Fairing
71.2.5.1.1
Reach through door in lower left
fairing and disconnect anti-collision light
connector.
71.2.5.1.2
Open driveshaft cover which
overlaps upper fairing. Release fasteners and
remove upper and two lower tailpipe fairings.
71.2.5.2 Inspection – Tailpipe Fairing
71.2.5.2.1
Inspect for damage, cracks, and
dents.
71.2.5.2.2
Inspect fasteners for
serviceability.
71.2.5.3 Installation – Tailpipe Fairing
71.2.5.3.1
Install and fasten lower fairings
and upper fairing. Close driveshaft cover.
71.2.5.3.2
Reach through door on lower
left fairing and connect anti-collision light
connector at deck.