Pag
e 80
P-Sensor is detected - orange LED flashes
S-Sensor is detected - green LED flashes
•
Are the sensors detected?
If the battery connects to the drive
unit and the starting melody plays, you
should check whether the sensors are
detected.
See p. 54.
Important!
The sensors are only displayed
at level 0/Off.
If the sensors have been accidentally
reset in the add-e NE
X
T app, they need to
be paired again.
See p. 56
.
9.3 The drive unit cuts out while riding
Push the motor up to the highest position
If the drive unit cuts out with a beep
while riding, the ASC (anti-slip control),
the tyre pressure and, if necessary, the
drive setting need to be adjusted. This
mainly occurs when riding uphill with a
high level of assistance.
If the distance between the drive unit
and the rear wheel has changed, it needs
to be adjusted and the system setting
also needs to be checked.
It is important that this is done systema-
tically and in the correct order.
See pp. 25-30 Section 3: Drive & mechani-
cal setting.
9.4 The drive "paws"
What is termed "pawing" or also "kno-
cking" of the drive unit is caused by to
high contact pressure. This is especially
the case at low power levels when the
drive tries to engage with the tyre.
Pawing can also be associated with the
upper stop setting.
Reducing the contact pressure and
adjusting the upper stop can solve this
problem.
Adjust the contact pressure
