Pag
e 18
1. Attach the short assembly arms to
each side of the stand plate using the
six M4 Torx screws supplied.
1.2.2. Assembling the damper plate
When fitting the drive unit to the bottom bracket, preferably the short assembly
arms should be used. Check whether the bike's frame allows this as follows:
Assembling the damper plate
2. Place the setting gauge on the as-
sembled damper plate and
point the
wedge on the damper plate towards
the chain ring
.
Loosely attach the assembly arms to
the bottom bracket using the bottom
bracket shells.
The setting gauge should rest against
the rear wheel. If this is not the case,
use the long assembly arms.
Short assembly arms - right lenght
p
ATTENTION!
If the distance between the setting gauge and the rear wheel is too
large, use the long assembly arms! However, if these are too long,
the stand plate angle for fitting the drive unit will be too acute.
Right fitting later on is not possible.
Short assembly arms too short
Long assembly arms too long
