Pag
e 23
PLEASE NOTE!
To minimise the risk of injury, do not trim the steel straps too long
and do not leave any sharp cutting edges. The steel straps can only
be used once.
Secure the steel straps
8. Bend the trimmed ends of the steel
straps by 90 degrees and insert them
into the slots.
Press the steel straps flat against the
battery holder with your thumb and
secure them with the second grub
screw.
If the trimmed ends are too short, the
grub screws will not engage, and the
steel strap cannot be pulled taut.
Tighten the steel straps
9. Tighten the grub screws alternately
until the steel straps fit tight around
the frame.
It is important not to overtighten the
steel straps, as this may cause dama-
ge or even tear them.
Attach ing battery holder with screw & steel strap
1. Attach the battery holder to one of
the available holes with an M5 Allen
screw.
2. Use at least one steel strap as a
second attachment method to the
frame.
See page 22 "Attaching the battery
holder with steel straps".
2.3. Variant 3: Attaching the battery holder with screw & steel strap
Attaching the battery holder with a screw and a steel strap comes into operation
when the available space allows to use only one of the pre-drilled holes on the
frame.
