Pag
e 26
1. Check the tyre pressure and correct
this if necessary.
The tyre pressure may vary depen-
ding on the manufacturer's specifica-
tions. It is usually impressed on the
tyre.
2. Place the setting gauge on the
damper plate and make sure it is in
contact with the tyre.
The setting gauge touches the tyre
3. Remove the setting gauge and un-
screw the setting screw for contact
pressure (2) on the wedge of the
damper plate by 2-3 mm.
Unscrew the screw by approx. 2-3 mm
4. Screw the setting screw for the lower
stop (4) completely back into the
housing of the drive unit to ensure
the maximum deflection of the swing
arm.
Screw in the setting screw for the lower stop (4)
2-3 mm
The following illustrations demonstrate the adjustment settings on the side stand
mounting position. The mechanical setting is carried out in the same way for instal-
lation variants 2 and 3.
ATTENTION!
For the optimal function of the drive unit, it is important to check
the correct setting and the tyre pressure regularly!
Preparation
