Pag
e 12
1. Place the damper plate in the stand
plate and attach the setting gauge.
2. The damper plate can be moved along
the stand plate so that the distance
between the setting gauge and the
rear wheel can be adjusted. Slide the
damper plate towards the rear wheel
until the setting gauge rests against
the tyre.
3. Ideally, it should be possible to tighten
three, but at least two M4 Torx screws
on each side in order to continue
installing the drive unit with the side-
stand mounting plate. -
See p. 14.
If this is not possible, another installa-
tion variant will have to be used.
The setting gauge is touching the rear wheel
Variant1 1: Installation at the side stand
If your bike has a side stand mounting, it can be used to install the drive. Make sure
that the side-stand mounting is sufficiently far away from the rear wheel and at a
suitable angle to the rear wheel hub. You can check this as follows:
ATTENTION!
If the angle is not correct, you can adjust it by using an underlay for
the stand plate. You can use aluminium or plastic plates or similar for
this purpose. See p. 15.
PLEASE NOTE!
The shape of the frame may prevent the setting gauge from coming
into contact with the rear wheel. If this is the case, rotate the stand
plate for 180°.
