Pag
e 29
1. To adjust the freewheel setting, park
the bike on a flat surface; never upside
down.
2. The distance between the motor and
the tyre should be 2-5 mm when
disengaged.
Distance motor to tyre approx. 5 mm
Setting 3: Freewheel
3. If the distance is less than 2-5 mm,
loosen the freewheel setting screw
(3) by one turn. You do not need to
unscrew it completely.
The motor "falls" down. If it does not,
slightly tap on the setting screw.
Loosen the freewheel setting screw, the
motor "falls" down
2-5 mm
PLEASE NOTE!
The freewheel setting screw is located on the chainring side of the
drive unit. If the setting screw is covered by the chainring, the drive
unit needs to be removed.
The freewheel setting screw (3) regulates the distance between the motor and the
tyre in the Off position. There is no friction between rear tyre and the motor and
therefore clean engagement and disengagement of the motor is ensured.
4. Push the motor up to the highest
position and hand-tighten the setting
screw (3) in this position.
When released, the motor swings into
its final position. The distance bet-
ween the motor and the tyre should
be 2-5 mm.
If the distance is too small, repeat the
procedure, but this time do not push
the swing arm all the way up to the
highest position.
Push the motor to the highest position
