
38
4.2.4 Alarm relay and setup
·
See Menu>Setting>Alarm
·
Connect alarm devices to your DVR
(e.g: light, bleeper, doorbell, siren, phone
dialer etc.)
This menu allows a variety of equipment to
be triggered via a relay switch, when the
schedule menu is set for alarm detection.
Alarm In
select input alarm channel
Source of Alarm
DVR or network input
Type
select device type according to voltage output mode e.g normally open
Enable Tour
triggers sequencing on alarms – set sequencing time in output menu
mode
Record Channel
sets the channels for recording when the alarm is triggered –
usually same as alarm input channel
Delay
time in seconds that alarm condition remains active following detection (10
seconds ~ 300 seconds)
PTZ Preset
not yet functional
Alarm Output
select alarm output relay devices – 3
rd
port is 12v controllable port
Show Message
highlight to set screen display when alarm triggered
Period 1
set alarm output time period
Alarm Out
highlight to trigger alarm within time period
Show Message
highlight to display screen message within time period
Period 2
set alarm output time period
Alarm Out
highlight to trigger alarm within time period
Show Message
highlight to display screen message within time period
(note above time periods must not overlap)